ADAS Calibrations
Static and dynamic calibrations performed to OEM procedure for forward cameras, radar and blind spot modules — mobile at your shop or in our bay.
DetailsADAS Calibration in Rowlett, TX
Dallas County · About 15 minutes from our Garland bay.
Rowlett is a short hop from the shop. We cover mobile ADAS calibration, SRS and electrical diagnostics, and ECU programming for Rowlett shops and vehicle owners.
Working in Rowlett
Because we're close, Rowlett vehicles that need a static calibration can come to the Garland bay and go back the same day rather than sitting waiting on a mobile slot.
Mobile or in-shop
We bring targets and equipment to Rowlett for calibrations that can be completed on site. Static procedures requiring a level floor, controlled lighting and exact target placement are performed in our Garland bay at 3002 Edgewood Dr, Ste 7.
What we do in Rowlett
Electrical Diagnostics
Fault-finding on the systems other shops hand back: SRS, network communication, sensors, power and ground faults — traced to the actual root cause.
DetailsECU Programming
Module programming and flashing with factory-level software, including setup and initialization of replacement modules.
DetailsOEM Pre & Post Scans
Documented pre-repair and post-repair health scans with complete reports your estimator and insurer can attach to the file.
DetailsWhen a Rowlett vehicle needs recalibration
- Windshield replacement
- Collision repair
- Front end alignment
- Suspension repair or ride-height change
- Camera or radar sensor replacement
- SRS deployment
- ECM, PCM or ECU replacement
- Change in tire size
- ADAS warning lights on or flashing codes
Frequently asked questions
- Does a windshield replacement require ADAS calibration?
- On almost any vehicle with a forward-facing camera mounted to the glass, yes. Removing and replacing the windshield changes the camera's position and aim, and manufacturers require a recalibration afterward. Skipping it means lane keeping, automatic emergency braking and forward collision warning may react late, early, or not at all.
- What is the difference between static and dynamic calibration?
- Static calibration is done with the vehicle stationary in a controlled space, using OEM targets set at exact distances and heights. Dynamic calibration is done by driving the vehicle at a specified speed on suitable roads while the module learns. Many vehicles require both, in a specific order — the manufacturer's procedure decides, not the shop.
- How long does a calibration take?
- Most single-system calibrations run 1 to 2 hours once the vehicle is prepped. Vehicles needing multiple systems, or a static plus dynamic procedure, can take half a day. Pre-existing faults, ride-height problems or bad alignment can add time because they must be corrected before calibration is valid.
- Do you come to my shop, or does the vehicle come to you?
- Both. We run mobile service across the Dallas–Fort Worth metroplex for calibrations and diagnostics that can be completed on site. Static calibrations that require a level floor, controlled lighting and precise target placement are performed in our Garland bay.
- What documentation do I get?
- A complete pre-repair scan, a post-repair scan confirming systems are clear, and calibration documentation for each system we worked on — printable and ready to attach to the repair file for the customer or the insurer.
Need a vehicle calibrated in Rowlett?
Send the vehicle details and we'll come back with scheduling and pricing.